Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 364 (MANUAL TRANSAXLE [SERVICE, REMOVAL & INSTALLATION A65M-R))MANUAL TRANSAXLE REMOVAL/INSTALLATIONMANUAL TRANSAXLE INSTALLATION NOTE
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Manual Transaxle Installation Note
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Manual Transaxle Installation Note
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Set the transaxle on a jack and lift into place.
- Install the transaxle mounting bolts.
- Install the stud of the No. 4 engine mount.
Tightening torque
27.4-40.2 N.m
{2.8-4.0 kgf.m, 20.2-29.6 ft.lbf}
- Tighten the SST (49 E017 5A0)so that the engine is located at the specified position.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.