Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 332 (SYMPTOM TROUBLESHOOTING (ENGINE CONTROL SYSTEM L3))ENGINE CONTROL SYSTEM OPERATION INSPECTIONVARIABLE TUMBLE SYSTEM OPERATION INSPECTIONROD OPERATION
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Rod operation
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Rod operation
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
ROD OPERATION (VARIABLE TUMBLE SYSTEM)
| Engine speed | 3, 750 rpm | |
| Below | Above | |
| Shutter valve actuator | Operate | Not operate |
- If the rod operation is not specified, inspect as follows:
- Verify that DTC No. P2004, P2006, P2009 or P2010 is not displayed.
- If DTC No. P2009 or P2010 are shown, perform DTC inspection.
(See DTC TABLE .)
- If DTC No. P2009 or P2010 are shown, perform DTC inspection.
- Inspect Variable tumble solenoid valve.
(See VARIABLE TUMBLE SOLENOID VALVE INSPECTION [L3 .)
- If the Variable tumble solenoid valve is not okay, replace Variable tumble solenoid valve.
- If the Variable tumble solenoid valve is okay, inspect the following:
- Vacuum hose and vacuum chamber for looseness or damage
- Shutter valve actuator
- Shutter valve stuck open or closed
- Verify that DTC No. P2004, P2006, P2009 or P2010 is not displayed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.