Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 329 (GENERAL INFORMATION)PRE-DELIVERY INSPECTIONPRE-DELIVERY INSPECTION TABLEINTERIOR
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Pre-Delivery Inspection Table: Interior
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Interior
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
INSTALL the following items:
- Fuse for accessories
INSPECT the operations of the following items:
- Seat controls (slide and recline) and headrests
- Folding rear seat
- Door locks, including childproof door locks
- Seat belts and warning system
- Ignition switch and steering lock
- Transaxle range switch
- Warning buzzers
- Ignition key reminder alarm
- Air bag system using warning light
- Cruise control system (if equipped)
- Power door lock
- Shift-lock system (if equipped)
- Starter interlock
- All lights including warning, and indicator lights
- Horn, wipers, and washers
- Wiper blades performance
Clean wiper blades and windshield, if necessary
- Antenna
- Audio system
- Cigarette lighter and clock
- Power windows (if equipped)
- Heater, defroster, and air conditioner at various mode selections (if equipped)
INSPECT the following items:
- Presence of spare fuse
- Upholstery and interior finish
INSPECT and ADJUST , if necessary, the following items:
- Operation and fit of windows
- Pedal height and free play of clutch pedal
- Parking brake
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.