SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 307 (SECURITY SYSTEM AND LOCKS SYSTEM)LIFTGATE WINDOW LATCHREMOVAL AND INSTALLATION
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Removal and Installation

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Removal and Installation
WARNING: This page is about a different car, the 2003 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Make sure the liftgate window glass is in the raised position.
  1. Remove the liftgate trim panel.
    Fig 1: Disconnecting Liftgate Window Latch
    G01903974Courtesy of MAZDA MOTORS CORP.
  2. Disconnect the liftgate window latch.
    1. Disconnect the liftgate window latch ajar switch electrical connector.
    2. Open the clip and disconnect the actuating rod.
      Fig 2: Removing Liftgate Window Latch
      G01903975Courtesy of MAZDA MOTORS CORP.
    NOTE:
    • Mark the position of the liftgate window latch prior to removing the nuts.
  3. Remove the liftgate window latch.
    1. Remove the bolts.
    2. Remove the latch.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.