Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Steering System
The power steering system has a typical rack-and-pinion design consisting of the following components:
- power steering fluid reservoir
- power steering pump
- steering gear
- fluid cooler
- fluid lines
- tie rods
- steering column
For information on the power steering pump reservoir, refer to POWER STEERING .
For information on the steering wheel and column assembly, refer to STEERING COLUMN .
For information on the power steering fluid lines, refer to POWER STEERING .
For information on the power steering pump, refer to POWER STEERING .
For information on the steering gear, refer to POWER STEERING .
For information on the tie rod end, refer to STEERING LINKAGE .
For information on the power steering fluid cooler, refer to POWER STEERING .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.