Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 275 (CONTROL SYSTEM (HVAC))PASSENGER COMPARTMENT TEMPERATURE SENSOR REMOVAL/INSTALLATION
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Passenger Compartment Temperature Sensor Removal/Installation
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Passenger Compartment Temperature Sensor Removal/Installation
WARNING: This page is about a different car, the 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Remove the lower panel. (See LOWER PANEL REMOVAL/INSTALLATIONS .)
- Remove in the order indicated in the table.PASSENGER COMPARTMENT TEMPERATURE SENSOR REMOVAL/INSTALLATION
1 Air Hose 2 Passenger Compartment Temperature Sensor Connector 3 Passenger Compartment Temperature Sensor - Install in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.