Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 233 (SYMPTOM TROUBLESHOOTING [ENGINE CONTROL SYSTEM 13B-MSP))INTERMITTENT CONCERN TROUBLESHOOTINGWATER SPRINKLING METHOD
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Water Sprinkling Method
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Water Sprinkling Method
WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Indirectly change the temperature and humidity by spraying water onto the front of the radiator.
- If a vehicle is subject to water leakage, the leakage may damage the control module. When testing a vehicle with a water leakage problem, special caution must be used.
If the malfunction occurs only during high humidity or rainy/snowy weather, perform the following steps:
- Connect the WDS or equivalent to the DLC-2 if you are inspecting sensors or switches.
- Turn the ignition switch to the ON position (Engine off).NOTE:
- If the engine starts and runs, perform the following steps at idle.
- Access the PIDs for sensors or switches if you are inspecting sensors or switches.
- If you are inspecting the switch, turn it on manually.
- Spray water onto the vehicle or run it through a car wash.
- If the PID value is unstable or malfunction occurs, repair or replace the part if necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.