SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 198 (GLASS/WINDOWS/MIRRORS)FRONT DOOR GLASS AND GUIDE REMOVAL/INSTALLATION
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Front Door Glass And Guide Removal/Installation

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Front Door Glass And Guide Removal/Installation
WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower or raise the front door glass so that the distance from the top of the front door glass at the rear end to the upper part of the front beltline molding is 185 mm {7.3 in}  .
  2. Disconnect the negative battery cable.
  3. Remove the front door trim. (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
    Fig 1: Positioning Front Door Glass For Front Door Glass & Guide Removal
    G02563924Courtesy of MAZDA MOTORS CORP.
  4. Remove in the order indicated in the table.
    REMOVING/INSTALLING FRONT DOOR GLASS & GUIDE

    Component/Step No. Component Description
    1 Inner Handle
    2 Front Door Trim Bracket
    3 Door Screen
    4 Front Door Glass (See FRONT DOOR GLASS DISASSEMBLY NOTE )
    5 Glass Run Channel
    Fig 2: Removing/Installing Front Door Glass & Guide
    G02563925Courtesy of MAZDA MOTORS CORP.
  5. Install in the reverse order of removal.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.