Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 189 (SYMPTOM TROUBLESHOOTING [ENGINE CONTROL SYSTEM AJ])ENGINE CONTROL SYSTEM OPERATION INSPECTIONIGNITION TIMING CONTROL INSPECTION
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Ignition Timing Control Inspection
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Ignition Timing Control Inspection
WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
- Start the engine and run it at idle.
- Warm up the engine to normal operating temperature.
- Connect the SSTs (WDS or equivalent) to the DLC-2.
- Select the PID/DATA MONITOR AND RECORD function on the WDS or equivalent display.
- Select the SPARKADV PID.
- Verify that SPARKADV PID is within the specification.
Specification: BTDC 4°-16° (10° +/- 6°)
- Increase the engine speed and verify that the SPARKADV PID value is advanced.
- If it is not advanced, inspect the following.
- CKP sensor and related harness (See CRANKSHAFT POSITION (CKP) SENSOR INSPECTION .)
- MAF sensor and related harness (See MASS AIRFLOW (MAF)/INTAKE AIR TEMPERATURE (IAT) SENSOR INSPECTION .)
- If it is not advanced, inspect the following.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.