SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 183 (DOORS AND LIFTGATE)EASY CLOSURE CONTROL MODULE INSPECTION
2008 Mazda 6 s Sport, 4D Hatchback, Standard

Easy Closure Control Module Inspection

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Easy Closure Control Module Inspection
WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the easy closure control module.
  2. Inspect for continuity between the latch position switch terminals using an ohmmeter.
    • If not as specified, replace the easy closure control module.
      Fig 1: Easy Closure Control Module Continuity Table
      G00997925Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.