Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 18 (GENERATORS & REGULATORS)SYSTEM TESTSTRIBUTETEST D: CHARGING SYSTEM OVERCHARGES BATTERY (2.0L)
2008 Mazda 6 s Sport, 4D Hatchback, Standard
Test D: Charging System Overcharges Battery (2.0L)
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Test D: Charging System Overcharges Battery (2.0L)
WARNING: This page is about a different car, the 2001 Mazda Tribute, 2001 Mazda B4000, 2001 Mazda B3000, 2001 Mazda B2500, and 2001 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.
- Connect New Generation Star (NGS) tester and retrieve Diagnostic Trouble Codes (DTCs). See MODULE COMMUNICATION NETWORK - TRIBUTE article under ACCESSORIES & EQUIPMENT. Attend to any DTCs as necessary. If no DTCs are present, disconnect NGS and go to next step.
- Start engine. Using DVOM, measure voltage at battery while varying engine RPM. If voltage is not greater than 15 volts, go to next step. If voltage is greater than 15 volts, go to step 4.
- Vary engine RPM and observe voltage gauge operation. If voltage gauge indicates more than 15 volts, then investigate instrument cluster fault. See INSTRUMENT CLUSTERS - TRIBUTE article under ACCESSORIES & EQUIPMENT. If voltage gauge does not indicate more than 15 volts, go to next step.
- Turn ignition switch to OFF position. Disconnect generator connector X-102a. See Figure. Start engine. Perform generator load test. See GENERATOR LOAD TEST under ON-VEHICLE TESTING. If generator is okay, go to next step. Replace generator if faulty. See GENERATOR under REMOVAL & INSTALLATION.
- Measure voltage between generator connector X-102a terminal No. 3 (Black/Yellow wire) and ground. If voltage drop is less then .5 volts, replace generator. See GENERATOR under REMOVAL & INSTALLATION. If measured voltage drop is .5 volts or more, repair open circuit in Black/Yellow wire. See WIRING DIAGRAMS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.