Hood Switch Inspection

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Hood Switch Inspection
WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Hood switch has a built-in hood lock.
  1. Open the hood.
  2. Disconnect the negative battery cable.
  3. Remove the radiator grille.
  4. Disconnect the hood switch connector.
  5. Using an ohmmeter, inspect for continuity between the hood switch terminals A and B.
    • If there is no continuity, replace the hood switch.
    Fig 1: Locating Hood Lock Unlock Position
    G01026856Courtesy of MAZDA MOTORS CORP.
  6. Lock the hood lock using a flathead screwdriver
  7. Inspect for continuity between the hood switch terminals A and B using an ohmmeter.
    • If there is continuity, replace the hood switch.
    CAUTION:
    • After the inspection, unlock the hood lock. If closing the hood with the hood lock locked, the hood lock and/or hood striker may be broken.
Fig 2: Locking Hood Lock
G01026857Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.