Windshield Wiper Motor Inspection

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Windshield Wiper Motor Inspection
WARNING: This page is about a different car, the 2002 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the windshield wiper motor connector.
  2. Connect battery positive voltage to terminal D or C and ground to terminal F, and inspect the operation of the windshield wiper motor as indicated below.
    Fig 1: Testing Windshield Wiper Motor
    G01196683Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.