Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1 (ENGINE CONTROLS - SYSTEM & COMPONENT TESTING)MISCELLANEOUS CONTROLSCOOLING FAN1-SPEED MOTOR
2008 Mazda 6 s Sport, 4D Hatchback, Standard
1-Speed Motor
2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION 1-Speed Motor
WARNING: This page is about a different car, the 2001 Mazda Protege, 2001 Mazda Millenia, 2001 Mazda MX-5 Miata, 2001 Mazda MPV, and 2001 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure battery is fully charged. Disconnect cooling fan motor connector. Connect ammeter between positive battery terminal and positive cooling fan motor connector. Ground negative cooling fan terminal. See appropriate wiring diagram under WIRING DIAGRAMS in ELECTRIC COOLING FANS article.
- Ensure cooling fan motor operates smoothly at specified current. See COOLING FAN MOTOR CURRENT SPECIFICATIONS table. If cooling fan motor draws more or less than specified amperage, check wiring. If wiring is okay, replace cooling fan motor.
COOLING FAN MOTOR CURRENT SPECIFICATIONS
| Application | Current Draw - Amps | ||
|---|---|---|---|
| Miata | 4.5-6.49 | ||
| Millenia | |||
| 2.5L | 8.5-11.5 | ||
| 2.3L | |||
| Low Speed | 9.0-15.0 | ||
| High Speed | 12.3-18.3 | ||
| MPV | 11.8-14.8 | ||
| Protege | |||
| With M/T | 2.4-4.4 | ||
| With A/T | 5.2-7.2 | ||
| 626 | 4.3-7.3 | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.