SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISON-BOARD DIAGNOSTIC [ENGINE CONTROL SYSTEM (AJ]DTC P0602 [AJ]NOTES
2008 Mazda 6 s Sport, 4D Hatchback, Standard

DTC P0602 [AJ]: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes
DTC P0602 [AJ] DETECTION CONDITION AND POSSIBLE CAUSES

DTC P0602 PCM programming error
DETECTION CONDITION 
  • No configuration data in PCM.
NOTE:
  • If the "PCM CONFIGURATION" is successful, the PCM stores DTC P0602 and illuminates the MIL (system is normal). Clear DTC P0602 using the M-MDS after the "PCM CONFIGURATION".
  • The MIL goes out after three drive cycles with no failure (DTCs remain in PCM).

Diagnostic support note 
  • This is a continuous monitor (CCM).
  • MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.
  • FREEZE FRAME DATA is available.
  • DTC is stored in PCM memory.
POSSIBLE CAUSE 
  • Complete configuration has not been completed
  • PCM malfunction
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.