SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20086 S SPORT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISON-BOARD DIAGNOSTIC [ENGINE CONTROL SYSTEM (AJ]DTC P0550 [AJ]NOTES
2008 Mazda 6 s Sport, 4D Hatchback, Standard

DTC P0550 [AJ]: Notes

2008 Mazda 6 s Sport, 4D Hatchback, StandardSECTION Notes
DTC P0550 [AJ] DETECTION CONDITION AND POSSIBLE CAUSES

DTC P0550 PSP switch circuit malfunction
DETECTION CONDITION 
  • The PCM monitors the PSP switch signal at PCM terminal 2T. If the input voltage is low (switch stays on) for 1 min  when the VSS is 60.2 km/h {37.4 mph} or above  and the ECT is 60°C {140°F} or above  , the PCM determines that the PSP switch circuit has a malfunction.

Diagnostic support note 
  • This is a continuous monitor (CCM).
  • MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
  • PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
  • FREEZE FRAME DATA is available.
  • DTC is stored in PCM memory.
POSSIBLE CAUSE 
  • PSP switch malfunction
  • Connector or terminal malfunction
  • Short to ground circuit between PSP switch terminal A and PCM terminal 2T
  • PCM malfunction
G04324200
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.