Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20083 S TOURING, 4D HATCHBACK, 2.3 4, STANDARDREPAIR AND DIAGNOSISENGINE MECHANICALMECHANICALENGINE MECHANICAL - OVERHAUL - (LF, L3)CYLINDER BLOCK (II) DISASSEMBLYMAIN BEARING CAP DISASSEMBLY NOTE
2008 Mazda 3 s Touring, 4D Hatchback, 2.3 4, Standard
Main Bearing Cap Disassembly Note
2008 Mazda 3 s Touring, 4D Hatchback, 2.3 4, StandardSECTION Main Bearing Cap Disassembly Note
- Inspect the crankshaft end play. (See CRANKSHAFT INSPECTION .)
- Loosen the main bearing cap bolts in two or three steps in the order shown in the figure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.