2007 Mazda B2300 L4-2.3LFACTORY OEM SERVICE PROCEDURE

Ignition Switch: Service and Repair



Ignition Switch

Factory service manual diagram





Removal and Installation

1. Depower the supplemental restraint system (SRS). See DEPOWERING AND REPOWERING.
2. Remove the 2 bolts and position the hood latch release handle aside.
3. Remove the screws and the lower instrument panel steering column cover.
4. Remove the 5 instrument panel steering column opening cover reinforcement bolts and the reinforcement panel.
- To install, tighten to 7 N-m (0.7 kgf-m, 62 in-lb).
5. Disconnect the ignition switch electrical connector.

Note:
- The ignition switch should be in the OFF position.

6. Remove the 2 ignition switch screws and the ignition switCh.
- To install, tighten to 6 N-m (0.6 kgf-m, 53 in-lb).
7. To install, reverse the removal procedure.
- Repower the SRS. See DEPOWERING AND REPOWERING.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.