2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE

Manifold Absolute Pressure (Map) Sensor Inspection: Notes

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flow diagram. (See TROUBLESHOOTING PROCEDURE .)
  1. Connect the M-MDS or equivalent to the DLC-2.
  2. Fig 1: Identifying Data Link Connector DLC-2
    G04323062Courtesy of MAZDA MOTORS CORP.
  3. Turn the ignition switch to the ON position (Engine off).
  4. Select MAP PID on the M-MDS or equivalent.
  5. Verify that the MAP PID (pressure) and barometric pressure are practically equal.
  6. Apply vacuum of -25.0 kPa {-187 mmHg, -7.38 inHg}  to the MAP sensor, and verify that the MAP variation from that of Step  4 is approx. 25.0 kPa {187 mmHg, 7.38 inHg}. 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.