2007 Mazda 6 MazdaspeedFACTORY OEM SERVICE PROCEDURE

Manifold Absolute Pressure (Map) Sensor Removal/Installation

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery cover.
  2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  3. Remove the dynamic chamber. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION .)
  4. Remove the MAP sensor.
    Fig 1: Removing Manifold Absolute Pressure Sensor
    G04323065Courtesy of MAZDA MOTORS CORP.
  5. Install in the reverse order of removal.

    MAP sensor tightening torque 

    2.7-3.7 N.m {28-37 kgf.cm, 24-32 in.lbf} 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.