Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2006B4000 BASE, AUTOMATICREPAIR AND DIAGNOSISSTEERINGPOWER STEERINGPOWER STEERING SYSTEMIGNITION KEY RELEASE BUTTONREMOVAL AND INSTALLATION
2006 Mazda B4000 Base, Automatic
Removal and Installation
2006 Mazda B4000 Base, AutomaticSECTION Removal and Installation
- Disconnect the negative battery cable. See BATTERY DISCONNECT .
- Remove the ignition switch lock cylinder. See IGNITION LOCK CYLINDER - FUNCTIONAL or see IGNITION LOCK CYLINDER - NON FUNCTIONAL .
- If equipped, remove the tilt release lever/ handle.
- Remove the 3 steering column cover screws and the upper and lower steering column covers.
- Remove the key release button bolt and the key release button and spring.
- To install, tighten to 5 N-m (0.5 kgf-m, 44 in-lbf).
- To install, reverse the removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.