SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2006B4000 BASE, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE SYMPTOM TROUBLESHOOTING - (5 OF 5)SYMPTOM TROUBLESHOOTING CHART - CRUISE CONTROLCRUISE CONTROL SYSTEM PINPOINT TEST 4: CRUISE CONTROL DOES NOT DISENGAGE WHEN THE CLUTCH IS APPLIED
2006 Mazda B4000 Base, Automatic

Cruise Control System Pinpoint Test 4: Cruise Control Does Not Disengage When The Clutch Is Applied

2006 Mazda B4000 Base, AutomaticSECTION Cruise Control System Pinpoint Test 4: Cruise Control Does Not Disengage When The Clutch Is Applied
CRUISE CONTROL SYSTEM PINPOINT TEST 4: CRUISE CONTROL DOES NOT DISENGAGE WHEN THE CLUTCH IS APPLIED

PINPOINT TEST 4 CRUISE CONTROL DOES NOT DISENGAGE WHEN THE CLUTCH IS APPLIED
STEP INSPECTION ACTION
1 CHECK THE CLUTCH PEDAL POSITION (CPP) SWITCH
  • Key in OFF position.
  • Disconnect: CPP switch 0119-03.
  • Measure the resistance between the CPP switch 0119-03 pin 4 (component side) and the CPP switch 0119-03 pin 3 (component side), while applying and releasing the clutch pedal.
  • Is the resistance less than 5 ohms with the clutch pedal released and greater than 10, 000 ohms with the clutch pedal applied? 
 Yes Install a new cruise control servo. See CRUISE CONTROL SERVO REMOVAL / INSTALLATION . Test the system for normal operation. See SYMPTOM TROUBLESHOOTING CHART - CRUISE CONTROL  .
No Install a new CPP switch.
See CLUTCH PEDAL POSITION (CPP) SWITCH REMOVAL / INSTALLATION . Test the system for normal operation. See SYMPTOM TROUBLESHOOTING CHART - CRUISE CONTROL  .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.