SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2006B4000 BASE, AUTOMATICREPAIR AND DIAGNOSISDRIVELINES & AXLESDIFFERENTIALS & DRIVE AXLESSYMPTOM TROUBLESHOOTING [DRIVELINE/AXLE]TRANSFER CASE ELECTRONIC SHIFT PINPOINT TEST 2: NO COMMUNICATION WITH THE 4WD CONTROL MODULE
2006 Mazda B4000 Base, Automatic

Transfer Case Electronic Shift Pinpoint Test 2: No Communication With The 4WD Control Module

2006 Mazda B4000 Base, AutomaticSECTION Transfer Case Electronic Shift Pinpoint Test 2: No Communication With The 4WD Control Module
TRANSFER CASE ELECTRONIC SHIFT PINPOINT TEST 2 CHART - NO COMMUNICATION WITH 4WD CONTROL MODULE

PIN POINT TEST 2 NO COMMUNICATION WITH THE 4WD CONTROL MODULE
STEP INSPECTION ACTION
1 CHECK POWER TO 4WD CONTROL MODULE
  • Key OFF.
  • Disconnect the 4WD control module connectors 0318-02 and 0318-03.
  • Key ON, engine OFF (KOEO).
  • Measure the voltage between 4WD control module 0318-02 pin 1, circuit (O), harness side and ground.
  • Measure the voltage between 4WD control module 0318-02 pin 2, circuit (DG/LG), harness side and ground.
  • Are both voltages greater than 10 volts? 
 Yes Go to step 2.
No Repair the power supply circuit. Test the system for normal operation.
2 CHECK 4WD CONTROL MODULE GROUND CIRCUITS
  • Key OFF.
  • Measure the resistance between 4WD control module 0318-02 pin 7, circuit (B), harness side and ground.
  • Measure the resistance between 4WD control module 0318-03 pin 2, circuit (B/W), harness side and ground.
  • Are both resistances less than 5 ohms? 
 Yes Replace the 4WD control module. See 4WD CONTROL MODULE REMOVAL / INSTALLATION . Test the system for normal operation.
No Repair the circuit.
Test the system for normal operation.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.