Ignition Switch Inspection

2006 Mazda B4000 Base, AutomaticSECTION Ignition Switch Inspection
  1. Remove the ignition switch. See IGNITION SWITCH  .
  2. Inspect for continuity between the ignition switch terminals using an ohmmeter.
    Fig 1: Inspecting Ignition Switch
    G04310564Courtesy of MAZDA MOTORS CORP.

    Inspection 

    INSPECTION CHART

    Circuit to test Connect self-powered test light or ohmmeter to terminals Move switch to these positions A good switch will indicate
    Run power circuit B1 and A1
    B2 and A2
    B4 and A4
    Off/lock Open circuit
    Accessory Open circuit
    Run Closed circuit
    Start Open circuit
    Run/start power circuit B5 and 11 Off/lock Open circuit
    Accessory Open circuit
    Run Closed circuit
    Start Closed circuit
    Ace power circuit B5 and A1 Off/lock Open circuit
    Accessory Closed circuit
    Run Open circuit
    Start Open circuit
    Start power circuit B4 and STA Off/lock Open circuit
    Accessory Open circuit
    Run Open circuit
    Start Closed circuit
  3. If not as specified, replace the ignition switch.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.