Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2006B4000 BASE, AUTOMATICREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSTROUBLESHOOTING (LIGHTING SYSTEM)INTERIOR LIGHTINGINSPECTION AND VERIFICATION
2006 Mazda B4000 Base, Automatic
Inspection and Verification
2006 Mazda B4000 Base, AutomaticSECTION Inspection and Verification
- Verify the customer concern.
- Visually inspect the following for obvious signs of mechanical or electrical damage.
Visual Inspection Chart
VISUAL INSPECTION CHARTMechanical Electrical - Door ajar switch(es)
- Smart junction box fuse 13 (15A)
- Lamp
- Circuitry
- If an obvious cause of an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
- If the cause is not visually evident, connect the WDS or equivalent tester to the data link connector (DLC) and select the vehicle to be tested from the WDS or equivalent tester menu. If the WDS or equivalent tester does not communicate with the vehicle:
- check that the program card is correctly installed.
- check the connections to the vehicle.
- check the ignition switch position.
- If the WDS or equivalent tester still does not communicate with the vehicle, refer to the WDS or equivalent tester operating manual.
- Carry out the data link diagnostics test. If the WDS or equivalent tester responds with:
- ISO circuits fault; all electronic control units no response/not equipped, see COMMUNICATIONS NETWORK .
- No response/not equipped for. the SJB, see MODULE CONTROLLED FUNCTIONS .
- System passed, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs and carry out the self-test diagnostics for the SJB.
- If the DTCs retrieved are related to the concern, see SMART JUNCTION BOX (SJB) DIAGNOSTIC TROUBLE CODE (DTC) INDEX .
- If no DTCs related to the concern are retrieved, see SYMPTOM TROUBLESHOOTING CHART - INTERIOR LIGHTING .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.