Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Mode 1 (PCM Adaptive Memory)
Check RFC FLAG PID. If PID is on, go to Mode 2. If PID is off, complete Mode 1 before performing Mode 2 or 3. Connect scan tool. Turn all accessories off. Start engine. Allow engine to reach operating temperature. Ensure idle speed and timing are within specification. With vehicle in Park, raise engine speed to 2000-3000 RPM for more than 15 seconds. Raise engine speed to 4000-5000 RPM for more than 15 seconds. Release throttle and allow to idle for more than 20 seconds after cooling fan has stopped. Turn ignition off. Turn ignition on. Using scan tool, check drive mode completion status. If cycle is not complete, repeat cycle from engine start.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.