SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2006B4000 BASE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESDRIVESHAFT & UNIVERSAL JOINTSPROPELLER SHAFTSINGLE CARDAN UNIVERSAL JOINT (FLANGE YOKE) DISASSEMBLY / ASSEMBLY)ASSEMBLY NOTE
2006 Mazda B4000 Base, Automatic

Assembly Note

2006 Mazda B4000 Base, AutomaticSECTION Assembly Note
  1. Install the spider.
    1. Start a new bearing cup into the propeller shaft yoke.
    2. Position the new spider in the propeller shaft yoke.
    3. Position the propeller shaft in U-Joint Tool SST.
    4. Press the bearing cup to just below the snap ring groove.
    5. Repeat for the other bearing cup.
    Fig 1: Installing Spider
    G04308990Courtesy of MAZDA MOTORS CORP.
  2. Install the propeller shaft flange yoke.
    1. Start a new bearing cup into the propeller shaft flange yoke.
    2. Position the propeller shaft flange yoke.
    3. Position the propeller shaft in U-Joint Tool SST.
    4. Press the bearing cup to just below the snap ring groove.
    5. Repeat for the other bearing cup.
    Fig 2: Pressing The Bearing Cup
    G04308991Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.