SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20066 S, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLON-BOARD DIAGNOSTIC [DYNAMIC STABILITY CONTROL)DTC C1095, C1096 [DSC]NOTES
2006 Mazda 6 s, 4D Sedan, Standard

DTC C1095, C1096 [DSC]: Notes

2006 Mazda 6 s, 4D Sedan, StandardSECTION Notes
DTC C1095, C1096 [DSC] DETECTION CONDITION AND POSSIBLE CAUSES

DTC C1095, C1096 Motor relay, pump motor
DETECTION CONDITION 
  • C1095:
    • No motor monitor signal congruency is detected in relation to DSC HU/CM ON signal
  • C1096:
    • No motor monitor signal congruency is detected in relation to DSC HU/CM OFF signal
    • Motor monitor ON signal is not input after specified time when the motor signal is switched from ON to OFF by DSC HU/CM
POSSIBLE CAUSE 
  • Malfunction of fuse (ABS 60 A)
  • Open circuit in harness between DSC HU/CM terminal D and battery positive terminal
  • Open circuit in harness between DSC HU/CM terminal B and body ground
  • Open or short of motor relay and/or pump motor in DSC HU/CM
  • Stuck motor relay and/or pump motor in DSC HU/CM
G04325867Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.