Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20066 S, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSGLASS/WINDOWS/MIRRORSPOWER WINDOW INITIALIZATION PROCEDURE
2006 Mazda 6 s, 4D Sedan, Standard
Power Window Initialization Procedure
2006 Mazda 6 s, 4D Sedan, StandardSECTION Power Window Initialization Procedure
NOTE:
- Initial setting must be performed for the switch of each window front and rear.
- If the following operations have been performed, initial setting is reset, and auto up/down and two-step down operation are disabled. Therefore, performing initial setting is necessary.
- Negative battery cable disconnected or power window system power supply fuse removed (perform initial setting for the switches of all seats.
- Power window switch connector disconnected (Perform initial setting for the switch connected with the connector.
- Prolonged open/close operation of the power window main or sub switches causes the circuit breaker to activate and automatic operation is disabled.
- Turn the ignition switch to the ON position.
- Press the switch of each window and fully open the door glass.
- Pull the switch of each window to the manual-up position to fully close the door glass, and keep holding the switch up at the position for approx. 2 s .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.