Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20066 S, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTSTEERING COLUMN SWITCHESLIGHTING SYSTEMSTEERING ANGLE SENSOR INSPECTION
2006 Mazda 6 s, 4D Sedan, Standard
Steering Angle Sensor Inspection
2006 Mazda 6 s, 4D Sedan, StandardSECTION Steering Angle Sensor Inspection
- Disconnect the steering angle sensor connector.
- Connect battery positive voltage to terminal A and ground to terminal F of the steering angle sensor.
- Turn the steering wheel to the right and left, and verify that the voltage and pulses at the terminals are as shown in the figure.
- If there is any malfunction, replace the body of the combination switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.