SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20066 S, 4D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMON-BOARD DIAGNOSTIC [ENGINE CONTROL SYSTEM AJ]DTC P2677NOTES
2006 Mazda 6 s, 4D Sedan, Standard

DTC P2677: Notes

2006 Mazda 6 s, 4D Sedan, StandardSECTION Notes
DTC P2677 [AJ] DETECTION CONDITION AND POSSIBLE CAUSES

DTC P2677 Variable air duct (VAD) solenoid valve circuit high input
DETECTION CONDITION 
  • The PCM monitors the VAD solenoid valve control signal current. If the following conditions are met, the PCM determines that there is the VAD control circuit problem.
    • The PCM turns the VAD solenoid valve on, but the current of the VAD solenoid valve control signal remains high.

Diagnostic support note 
  • This is a continuous monitor (Other).
  • The MIL does not illuminate.
  • PENDING CODE is available if the PCM detects the above malfunction condition.
  • FREEZE FRAME DATA is not available.
  • DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • VAD solenoid valve malfunction
  • Short to power supply between VAD solenoid valve terminal B and PCM terminal 1BB
  • Shorted VAD solenoid valve or PCM connector
  • PCM malfunction
G04324225
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.