SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20066 S, 4D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMON-BOARD DIAGNOSTIC [ENGINE CONTROL SYSTEM AJ]DTC P2401NOTES
2006 Mazda 6 s, 4D Sedan, Standard

DTC P2401: Notes

2006 Mazda 6 s, 4D Sedan, StandardSECTION Notes
DTC P2401 [AJ] DETECTION CONDITION AND POSSIBLE CAUSES

DTC P2401 EVAP system leak detection pump control circuit low
DETECTION CONDITION 
  • The PCM monitors the pump load current (EVAP line pressure) when the EVAP leak monitor is operating. If the pump load current is lower than specified, the PCM determines that the EVAP system leak detection pump motor circuit has a malfunction.

Diagnostic support note 
  • This is an intermittent monitor (CCM).
  • MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
  • PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
  • FREEZE FRAME DATA is available.
  • DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • EVAP system leak detection pump malfunction
  • Connector or terminal malfunction
  • Open circuit between main relay terminal C and EVAP system leak detection pump terminal A
  • Short to ground circuit between the EVAP system leak detection pump terminal D and PCM terminal 1Y
  • Open circuit between EVAP system leak detection pump terminal D and PCM terminal 1Y
  • PCM malfunction
G04324219
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.