SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20066 S, 4D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMON-BOARD DIAGNOSTIC [ENGINE CONTROL SYSTEM AJ]DTC P2127NOTES
2006 Mazda 6 s, 4D Sedan, Standard

DTC P2127: Notes

2006 Mazda 6 s, 4D Sedan, StandardSECTION Notes
DTC P2127 [AJ] DETECTION CONDITION AND POSSIBLE CAUSES

DTC P2127 APP sensor No.2 circuit low input
DETECTION CONDITION 
  • The PCM monitors the APP sensor No.2 signal at PCM terminal 1 AR If the PCM detects APP sensor No.2 voltage of 0.35 V or below  , the PCM determines that the APP sensor No.2 circuit has a malfunction.

Diagnostic support note 
  • This is a continuous monitor (CCM).
  • MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.
  • FREEZE FRAME DATA is available.
  • DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • APP sensor No.2 malfunction
  • Connector or terminal malfunction
  • Open circuit between APP sensor terminal A and PCM terminal 1AV
  • Short to ground circuit between APP sensor terminal A and PCM terminal 1AV
  • Open circuit between APP sensor terminal C and PCM terminal 1AP
  • Short to ground circuit between APP sensor terminal C and PCM terminal 1AP
  • PCM malfunction
G04324213
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.