SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20066 S, 4D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCHARGING SYSTEMSCHARGING SYSTEM (L3, AJ)GENERATOR INSPECTION [L3, AJ]GENERATOR INNER PARTSBRUSH
2006 Mazda 6 s, 4D Sedan, Standard

Generator Inner Parts: Brush

2006 Mazda 6 s, 4D Sedan, StandardSECTION Brush
  1. Inspect brushes for wear.
    • If any brush is worn almost to or beyond the limit, replace all of the brushes.

    Standard 22.5 mm {0.89 in} 

    Minimum 5.0 mm {0.20 in} 

    Fig 1: Inspecting Brushes For Wear
    G04325026Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.