Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA20066 S, 4D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESAXLE SHAFTSDRIVE SHAFTREAR DRIVE SHAFT DISASSEMBLY/ASSEMBLYSNAP RING DISASSEMBLY NOTE

2006 Mazda 6 s, 4D Sedan, Standard

Snap Ring Disassembly Note

2006 Mazda 6 s, 4D Sedan, StandardSECTION Snap Ring Disassembly Note

Mark the drive shaft end and inner ring for proper reassembly.
CAUTION:
- Mark with paint; do not use a punch.
Remove the snap ring using snap-ring pliers.

Fig 1: Removing Snap Ring
Courtesy of MAZDA MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.