SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20066 S, 4D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESAXLE SHAFTSDRIVE SHAFTFRONT DRIVE SHAFT DISASSEMBLY/ASSEMBLY [ATX]ABS SENSOR ROTOR (WITH ABS) DISASSEMBLY NOTE
2006 Mazda 6 s, 4D Sedan, Standard

ABS Sensor Rotor (With ABS) Disassembly Note

2006 Mazda 6 s, 4D Sedan, StandardSECTION ABS Sensor Rotor (With ABS) Disassembly Note
CAUTION:
  • Do not remove the sensor rotor unless it is necessary.
  • Do not reuse the sensor rotor if removed.
  1. Tap the ABS sensor rotor off the drive shaft using a chisel.
    Fig 1: Taping ABS Sensor Rotor Drive Shaft
    G04325650Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.