Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMAZDA20066 S, 4D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESMECHANICAL - HYDRAULICCONVENTIONAL BRAKE SYSTEMFRONT BRAKE (DISC) REMOVAL/INSTALLATION [L3, AJ]NOTES

2006 Mazda 6 s, 4D Sedan, Standard

Front Brake (Disc) Removal/Installation [L3, AJ]: Notes

2006 Mazda 6 s, 4D Sedan, StandardSECTION Notes

Remove in the order indicated in the table.
Install in the reverse order of removal.
After installation, depress the pedal a few times, rotate the wheel by hand, and verify that the brake does not drag.

Fig 1: Front Brake (Disc) Components & Torque Specification
Courtesy of MAZDA MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.