Security Access Procedure

2006 Mazda 6 i, 4D Sedan, AutomaticSECTION Security Access Procedure
NOTE:
  • When using the SST  (WDS or equivalent) to perform "Ignition Key Code Erase" or "Customer Spare Key Programming Enable/Disable", it is necessary to obtain security access approval.
  1. Connect the SST  (WDS or equivalent).
  2. Select "Tool box", "Body", "Security", and then "PATS Functions" (in this order).
  3. The SST  (WDS or equivalent) will read out an outcode depending on the designated procedure.
    CAUTION:
    • After reading out the outcode, do not turn ignition switch from LOCK to ON position 5 times, otherwise the outcode value will be changed.
  4. Access the Mazda official website to obtain the incode that corresponds to the outcode.
  5. Input the incode to the SST  (WDS or equivalent).
  6. Verify that the security access procedure finishes normally.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.