SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20066 I, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMON-BOARD DIAGNOSTIC [ENGINE CONTROL SYSTEM L3)OBD-II DRIVE MODEEVAP SYSTEM REPAIR VERIFICATION DRIVE MODE
2006 Mazda 6 i, 4D Sedan, Automatic

EVAP System Repair Verification Drive Mode

2006 Mazda 6 i, 4D Sedan, AutomaticSECTION EVAP System Repair Verification Drive Mode
NOTE:
  • If "EVAP System Repair Verification Drive Mode" cannot be performed (it is impossible to drive the vehicle under this drive mode condition), perform EVAP system test procedure as an alternative. (See ENGINE CONTROL SYSTEM OPERATION INSPECTION ).
  1. Verify that all of the following PIDs are within the following specifications. All PIDs must be within specifications before engine is started to initiate the EVAP system test.
    • BARO: more than 72.2 kPa {542 mmHg, 21.3 inHg} 
    • IAT: 5-40 °C {41-104 °F} 
    • FTL: 15-85% 
    • B+: more than 10.9 V 
  2. Clear the DTC from the PCM memory using the WDS or equivalent.
  3. Start the engine and idle it for more than 10 s  , then turn ignition switch off.
  4. Leave vehicle for 5 hours or more  .
  5. Start the engine and idle for more than 15 min  .
  6. Drive the vehicle at an engine speed of 65-80 km/h {40-50 mph}  for more than 5 min  .
  7. Stop the vehicle and turn ignition switch off.
  8. Leave vehicle as it is for 10 min or more  .
  9. Start the engine.
  10. Access the ON BOARD SYSTEM READINESS to verify the OBD monitoring status.
    • If completed, the OBD monitoring status items change from non-completed to completed.
    • If not completed, turn the ignition switch off then go back to Step 1.
  11. Access the DIAGNOSTIC MONITORING TEST RESULTS to verify the monitor results.
    • If detected values are not within specification, repair has not completed.
  12. Verify no DTCs are available.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.