SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20066 I, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMON-BOARD DIAGNOSTIC [ENGINE CONTROL SYSTEM L3)DTC P0704NOTES
2006 Mazda 6 i, 4D Sedan, Automatic

DTC P0704: Notes

2006 Mazda 6 i, 4D Sedan, AutomaticSECTION Notes
DTC P0704 DETECTION CONDITION AND POSSIBLE CAUSES

DTC P0704 Clutch pedal position (CPP) switch input circuit problem
DETECTION CONDITION 
  • The PCM monitors changes in input voltage from the CPP switch. If the PCM does not detect the voltage changes while the vehicle runs with vehicle speed above 30 km/h {19 mph}  and stops 8 times  alternately, the PCM determines that the CPP switch circuit has a malfunction.

Diagnostic support note 
  • This is a continuous monitor (CCM).
  • The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
  • PENDING CODE is available if the PCM detects the above malfunction condition during first drive cycle.
  • FREEZE FRAME DATA is available.
  • Are any DTCs is stored in the PCM memory.
POSSIBLE CAUSE 
  • CPP switch malfunction
  • Poor connection of CPP switch connector or PCM connector
  • Short to ground in wiring harness between CPP switch terminal B and PCM terminal 1D
  • Open circuit in wiring harness between CPP switch terminal B and PCM terminal 1D
  • Open circuit in wiring harness between ground and CPP switch terminal D
  • PCM malfunction
G04324044Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.