SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20066 I, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMON-BOARD DIAGNOSTIC [ENGINE CONTROL SYSTEM L3)DTC P0661NOTES
2006 Mazda 6 i, 4D Sedan, Automatic

DTC P0661: Notes

2006 Mazda 6 i, 4D Sedan, AutomaticSECTION Notes
DTC P0661 DETECTION CONDITION AND POSSIBLE CAUSES

DTC P0661 Variable intake air system solenoid valve circuit low input
DETECTION CONDITION 
  • PCM monitors variable intake air solenoid valve control signal. If PCM turns variable intake air solenoid valve off but voltage still remains low, PCM determines that variable intake air solenoid valve circuit has malfunction.

Diagnostic support note 
  • This is a continuous monitor (Other).
  • MIL does not illuminate.
  • PENDING CODE is available if PCM detects the above malfunction condition.
  • FREEZE FRAME DATA is not available.
  • DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • Variable intake air solenoid valve malfunction
  • Open circuit in wiring harness between main relay and variable intake air solenoid valve terminal A
  • Open circuit in wiring harness between variable intake air solenoid valve terminal B and PCM terminal 2J
  • Short to ground in wiring harness between variable intake air solenoid valve terminal B and PCM terminal 2J
  • Connector or terminal malfunction
  • PCM malfunction
G04324041Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.