SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20066 I, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMON-BOARD DIAGNOSTIC [ENGINE CONTROL SYSTEM L3)DTC P0223NOTES
2006 Mazda 6 i, 4D Sedan, Automatic

DTC P0223: Notes

2006 Mazda 6 i, 4D Sedan, AutomaticSECTION Notes
DTC P0223 DETECTION CONDITION AND POSSIBLE CAUSES

DTC P0223 TP sensor No. 2 circuit high input
DETECTION CONDITION 
  • If PCM detects TP sensor No. 2 voltage is above 4.85 V  after ignition switch to ON, PCM determines that TP circuit has a malfunction.

Diagnostic support note 
  • This is a continuous monitor (CCM).
  • MIL illuminates if PCM detects the above malfunction conditions in first drive cycles.
  • PENDING CODE is available if PCM detects the above malfunction condition.
  • FREEZE FRAME DATA is available.
  • DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • TP sensor malfunction
  • Connector or terminal malfunction
  • Open circuit between throttle body terminal B and PCM terminal 2AO
  • Open circuit between throttle body terminal D and PCM terminal 2AP
  • Short to constant voltage supply between throttle body terminal C and PCM terminal 2AL
  • PCM malfunction
G04324027Courtesy of MAZDA MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.