Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20066 I, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROL SYSTEM (L3)MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR INSPECTIONNOTES
2006 Mazda 6 i, 4D Sedan, Automatic
Manifold Absolute Pressure (Map) Sensor Inspection: Notes
2006 Mazda 6 i, 4D Sedan, AutomaticSECTION Notes
NOTE:
- Perform the following inspection only when directed.
- The following vacuum values are indicated by relative pressure from the MAP sensor.
- Connect the WDS or equivalent to the DLC-2.
- Turn the ignition switch to ON (Engine OFF).
- Select MAP PID on the WDS or equivalent.
- Verify that the MAP PID (pressure) and barometric pressure are practically equal.
- If not as verified, perform the "Circuit Open/Short Inspection".
- If there is no open or short circuit, replace the MAP sensor.
- If as verified, go to next step.
- If not as verified, perform the "Circuit Open/Short Inspection".
- Apply vacuum of -25.0 kPa {-187 mmHg, -7.38 inHg}
to the MAP sensor, and verify that the MAP variation from that of Step 4 is approx. 25.0 kPa {187 mmHg, 7.38 inHg}
.
- If not as verified, perform the "Circuit Open/Short inspection".
- If there is no open or short circuit, replace the barometric pressure sensor.
- If not as verified, perform the "Circuit Open/Short inspection".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.