Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20066 I, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALMECHANICALGENERAL INFORMATION [ENGINE MECHANICAL - LF & L3]UNITSNOTES
2006 Mazda 6 i, 4D Sedan, Automatic
General Information [Engine Mechanical - LF & L3]: Units: Notes
2006 Mazda 6 i, 4D Sedan, AutomaticSECTION Notes
UNITS DESCRIPTION
| Electric current | A (ampere) |
| Electric power | W (watt) |
| Electric resistance | ohm |
| Electric voltage | V (volt) |
| Length | mm (millimeter) |
| in (inch) | |
| Negative pressure | kPa (kilo pascal) |
| mmHg (millimeters of mercury) | |
| inHg (inches of mercury) | |
| Positive pressure | kPa (kilo pascal) |
| kgf/cm2 (kilogram force per square centimeter) | |
| psi (pounds per square inch) | |
| Number of revolutions | rpm (revolutions per minute) |
| Torque | N.m (Newton meter) |
| kgf.m (kilogram force meter) | |
| kgf.cm (kilogram force centimeter) | |
| ft.lbf (foot pound force) | |
| in.lbf (inch pound force) | |
| Volume | L (liter) |
| US qt (U.S. quart) | |
| lmp qt (Imperial quart) | |
| ml (milliliter) | |
| cc (cubic centimeter) | |
| cu in (cubic inch) | |
| fl oz (fluid ounce) | |
| Weight | g (gram) |
| oz (ounce) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.