Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20066 I, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALHORNSINSTRUMENTATION/DRIVER INFOINSTRUMENT CLUSTER INPUT/OUTPUT CHECK MODEINSPECTION OF CHECK CODESCHECK CODE 12
2006 Mazda 6 i, 4D Sedan, Automatic
Check code 12
2006 Mazda 6 i, 4D Sedan, AutomaticSECTION Check code 12
CHECK CODE 12 DIAGNOSTIC PROCEDURE
| Check code 12 | Operation signal to speedometer | ||
|---|---|---|---|
| INSPECTION | INDICATION | SITUATION | ACTION |
| Wait for 2 seconds after selecting check code 12. | Speedometer needle moves full scale then returns to 60 km/h or 60 MPH. | Speedometer is okay. | |
| Other than stated above. | Replace instrument cluster. | ||
| - | |||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.