Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20066 I, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLDYNAMIC STABILITY CONTROL SYSTEMDSC HU/CM CONFIGURATION
2006 Mazda 6 i, 4D Sedan, Automatic
DSC HU/Cm Configuration
2006 Mazda 6 i, 4D Sedan, AutomaticSECTION DSC HU/Cm Configuration
- Connect the WDS or equivalent to the DLC-2.
- Input vehicle information following the directions on the WDS or equivalent screen.
- Select "MODULE PROGRAMMING".
- Select "PROGRAMMABLE MODULE INSTALLATION".
- Select "ABS/TCS".
- Retrieve DTCs using the WDS or equivalent, then verify that there is no DTC present.
- If any DTC is present, perform applicable DTC inspection.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.