Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA20066 I, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSGLASS/WINDOWS/MIRRORSBASE INSTALLATION
2006 Mazda 6 i, 4D Sedan, Automatic
Base Installation
2006 Mazda 6 i, 4D Sedan, AutomaticSECTION Base Installation
- Cut away all of the original sealant using a razor.
- Clean and degrease the ceramic coating on the glass and the base.
- Apply primer to the bonding area of the glass and the base.CAUTION:
- Keep the area free of dirt and grease, and do not touch the surface. Otherwise, the primer may not properly bond to the surface of the glass.
- Apply a 3.0 mm {0.12 in}
layer of sealant to the base.NOTE:
- Use only glass primer on the glass, and body primer on the base. Allow the primer to dry for approx. 30 min .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.