Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Check code 33
2006 Mazda 6 i, 4D Sedan, AutomaticSECTION Check code 33
CHECK CODE 33 REFERENCE (HAZARD WARNING SWITCH)
| Check code 33 | Hazard warning switch on/off signal |
|---|---|
CHECK CODE 31 DIAGNOSTIC PROCEDURE
| STEP | INSPECTION | INDICATION | ACTION |
|---|---|---|---|
| 1 | Turn the hazard warning switch on after selecting check code 33. | Go to next step. | |
| Measure voltage at instrument cluster terminal 2N and 2R. Is voltage B+?
|
|||
| Measure voltage at instrument cluster terminal 2N and 2R. Is voltage 0 V?
|
|||
| 2 | Turn the hazard warning switch off. | Input signal to instrument cluster is okay. | |
| Other than fixed "OFF" | Inspect following parts.
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.