SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1999PROTEGE ES, AUTOMATICREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCKDIAGNOSIS & TESTINGRETRIEVING DIAGNOSTIC TROUBLE CODESWITHOUT USING NEW GENERATION STAR (NGS) SCAN TOOL
1999 Mazda Protege ES, Automatic

Without Using New Generation Star (NGS) Scan Tool

1999 Mazda Protege ES, AutomaticSECTION Without Using New Generation Star (NGS) Scan Tool
WARNING: Connecting jumper wire between incorrect DLC-1 terminal and chassis ground may cause damage and possible ABS malfunction. Ensure correct DLC-1 terminal is used before jumpering.

With ignition switch turned to OFF position, connect a jumper wire between DLC-1 terminal No. 13 and chassis ground. See Figure . Turn ignition switch to ON position (engine off). After ABS warning light illuminates for 3 seconds, ABS warning light will flash, indicating DTCs in memory. See Fig 1 . If any DTCs are present, see DIAGNOSTIC TROUBLE CODE IDENTIFICATION  table. Perform appropriate diagnostic test. See DIAGNOSTIC TESTS  . Clear DTCs after servicing. See CLEARING CODES  .

Fig 1: Identifying ABS Warning Light Flashing Pattern
G00009381Courtesy of MAZDA MOTORS CORP.
DIAGNOSTIC TROUBLE CODE IDENTIFICATION

DTC Description Test
11 Right Front Wheel Speed Sensor Circuit Failure A 
12 Left Front Wheel Speed Sensor Circuit Failure A 
13 Right Rear Wheel Speed Sensor Circuit Failure A 
14 Left Rear Wheel Speed Sensor Circuit Failure A 
22 Right Front Dump Valve Circuit Failure B 
24 Left Front Dump Valve Circuit Failure B 
26 Right Rear Dump Valve Circuit Failure B 
28 Left Rear Dump Valve Circuit Failure B 
29 RF & LR Speed Sensor No Input Signal During ABS Operation C 
30 LF & RR Speed Sensor No Input Signal During ABS Operation C 
32 Right Front Solenoid Valve Or ABS Motor D 
33 Left Front Solenoid Valve Or ABS Motor D 
34 Right Rear Solenoid Valve Or ABS Motor D 
35 Left Rear Solenoid Valve Or ABS Motor D 
41 Right Front Wheel Speed Signal Out Of Specification A 
42 Left Front Wheel Speed Signal Out Of Specification A 
43 Right Rear Wheel Speed Signal Out Of Specification A 
44 Left Rear Wheel Speed Signal Out Of Specification A 
45 Right Front Wheel Speed Sensor Signal Malfunction A 
46 Left Front Wheel Speed Sensor Signal Malfunction A 
47 Right Rear Wheel Speed Sensor Signal Malfunction A 
48 Left Rear Wheel Speed Sensor Signal Malfunction A 
51 Fail Safe Relay Malfunction B 
52 Fail Safe Relay Malfunction B 
53 ABS Motor Stuck Malfunction E 
54 ABS Motor Stuck Malfunction E 
61 ABS Control Module Malfunction F 
63 Low Power Supply To ABS CM (Below 10 Volts) G 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.