Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1999626 ES, 2.5 D, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 458 (ANTILOCK BRAKE SYSTEM)REAR ABS WHEEL-SPEED SENSOR INSPECTIONCLEARANCE INSPECTION
1999 Mazda 626 ES, 2.5 D, Standard
Clearance Inspection
1999 Mazda 626 ES, 2.5 D, StandardSECTION Clearance Inspection
WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Verify the clearance between the ABS sensor rotor and the ABS wheel-speed sensor.
- If there is any malfunction, check for improper installation, and replace if necessary.
Clearance
- 0.3-1.1 mm {0.012-0.043 in}
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.